Bennett-marine EIC5000 Electronic Indicator Control Manuale Utente Scaricare il pdf (Pagina 3)

EIC Installation Overview

nipple into actuator upper hinge. Tighten nipple hand tight. Then, with vise grips, tighten two full

turns … NO MORE. Cover end of pipe nipple with masking tape. If you have the short through-

transom tting, using a 7/16" wrench, screw it in until the tting is snug; the shoulder of the

tting will just touch the plastic of the upper hinge.

Step 7 - Carefully feed Sensor Wire through 5/16" hole. Apply sealant to actuator upper hinge

surface around pipe nipple, screw holes, and cable. Secure actuator upper hinge to transom with

mounting screws. Grasp cylinder body with both hands and tighten (clockwise) securely.

Step 8 - Inside transom, remove masking tape from pipe nipples. Carefully wrap Teon tape

around male threads of pipe nipples. Holding pipe nipples with vise grips (to prevent them from

turning) re-secure 90 degree elbows. Re-attach hydraulic tubing, tightening nut nger tight.

Snug nut with 1/2" wrench. Do not over-tighten. Note: If you have the short through-transom

ttings, omit this step. Repeat for other side. Run Red and Green Sensor Wires to where you plan

to mount the EIC Module.

Step 9 - Mounting the EIC Display

Using the template on the last page, mark the location for your EIC Display and locate the centers

of the holes. Use a 2" hole-saw to cut the center hole and 3/16" drill for the four mounting stud

holes. Use a small bead of sealant around the perimeter of the display to seal. Plug the EIC Harness

(blue cable) into the back of the EIC Display. Use the 4 nylon thumb nuts to secure the display (use

care to avoid over-tightening).

EIC Relay Module Power Lead

Orange (12 Volt +)

Black (12 Volt - )

Purple Power Lead

Orange Power Lead

Spare

ATC Lead

Starboard (Green)

Sensor Wire

Port (Red) Sensor Wire

Black Ground

Wire from HPU

Four-Color HPU

Wire Harness

EIC Relay Module

HPU

EIC Display

1 2 3 4 5 6 7 8 9

Nessun commento

Bennett-marine EIC5000 Electronic Indicator Control Manuale Utente Pagina 3